Marine Construction in Port Bolivar, Texas

Reliable work focused on site conditions, material selection and long-term performance

Waterfront Work at the Galveston Bay Entrance on the Bolivar Peninsula

Port Bolivar sits on the northern shore of the western tip of the Bolivar Peninsula, across the entrance to Galveston Bay from Galveston Island. A state ferry runs between the two, and the North Jetty reaches out from the peninsula at the bay entrance. The historic Bolivar Lighthouse once guided ships into the bay from here.

The peninsula is a narrow strip between Galveston Bay and the Gulf, and Hurricane Ike in September 2008 showed how exposed that is. Peak coastal surge reached 21 feet, at least 5 feet of water covered the whole peninsula, and authorities counted 3,600 structures destroyed or severely damaged. A USGS study of Ike found that elevation was the main factor in whether a building survived where waves were large. For waterfront structures, that points toward higher decks, deep pilings and walls with well-protected backfill.

We handle Marine Construction in Port Bolivar, TX on the bay side and along nearby channels: bulkheads, seawalls and retaining walls, piers, docks and boat slips. Our pile crews drive marine pilings for new builds and for structures that need more support, and we repair walls and docks worn down by salt and storms.

If you are planning work near the ferry landing or farther up the peninsula, send us the address and some photos, and we will get back to you with a free preliminary estimate.

Marine Construction in Port Bolivar, Texas

Bulkhead Construction and Repair in Port Bolivar, TX

Bulkheads for Port Bolivar lots on the Galveston Bay side of the peninsula

Marine Construction in Port Bolivar, Texas

Seawall Construction and Shoreline Protection in Port Bolivar, TX

Seawalls for Port Bolivar frontage facing surge at the Galveston Bay entrance

Marine Construction in Port Bolivar, Texas

Retaining Wall Construction in Port Bolivar, TX

Retaining walls that hold raised grade on Bolivar Peninsula lots in Port Bolivar

Marine Construction in Port Bolivar, Texas

Pier Construction and Installation in Port Bolivar, TX

Piers on Galveston Bay off Port Bolivar, set high with deep pilings

Marine Construction in Port Bolivar, Texas

Dock and Boat Slip Construction in Port Bolivar, TX

Docks and boat slips for Port Bolivar homes with access to Galveston Bay

Marine Construction in Port Bolivar, Texas

Marine Piling Installation Services in Port Bolivar, TX

Marine pilings for Port Bolivar docks and walls in surge-exposed bay water

Marine Construction in Port Bolivar, Texas

Waterfront Structure Repair and Maintenance in Port Bolivar, TX

Repair of salt-worn and storm-damaged waterfront structures in Port Bolivar

Marine Construction in Port Bolivar, Texas

Trust the Professionals!

Get a Free Consultation and Preliminary Cost Estimate
Marine Construction in Port Bolivar, Texas

Frequently Asked Questions About Marine Construction in Port Bolivar, TX

How high should a dock deck sit in Port Bolivar?

There is no single number, but Ike showed that small differences in elevation decided what survived on the Bolivar Peninsula. We set deck height after looking at your site and typical high water.

Do you build on the Galveston Bay side near Port Bolivar?

Yes. Most docks, piers and bulkheads we look at around Port Bolivar face the bay side of the peninsula.

Why do Bolivar Peninsula walls lose fill after storms?

Surge pushes water over and behind a wall, and when it drains it can pull sand with it. Filter fabric, tight joints and solid anchors reduce that loss.

Can pilings near the Galveston Bay entrance be reused?

Sometimes. If the pilings are sound and deep enough, we can rebuild on them. Damaged or short pilings get replaced.

What do you need to quote a Port Bolivar job?

The address or a map pin, photos of the existing structure or shoreline and a short note on your plans. Our reply is a free preliminary estimate.

Close
Close
loading